Prices are in US Dollars

Made to Order

This product fits 1982-1992 Camaros

****Please note that this is the “3-Bulb” version. The video is of an outdated version (Version 1.0).

*** THIS version  Only 3 bulbs per side will sequence (Corner Marker Light, Brake Light, Turn Signal) ******

• Please use LEDs with this kit. (Please note that some LEDs are not compatible with this system. As it is difficult to determine which LEDs are compatible, I have designed my own compatible LEDs. You can find them listed in the store).

Troubleshooting

Features:

• Plug and play harness
• Sequential turn signals
• Brake lights sequence one time and then remain illuminated, until the brake pedal is released
• Sequential hazard lights
• Show Off Mode (See Below)

Notes:

• The factory signal light flasher will need to be upgraded to an electronic signal light flasher, to accommodate the electronics in the module (I sell an adjustable, electronic signal light flasher).
• Please use LEDs with this kit. (Please note that some LEDs are not compatible with this system. As it is difficult to determine which LEDs are compatible, I have designed my own compatible LEDs. You can find them listed in the store).

Installation:

• Locate and remove the existing signal light relay (engage the turn signal (Not Hazard Lights) and follow the ticking sound).
• Replace the original signal light relay with an electronic style (LED Compatible). BraveTECH electronic signal light relays are available for purchase.
• Remove tail lights.
• Remove the 6 bulbs that are used for running lights, brake lights, and turn signals. (Four 1157 bulbs and Two 194 bulbs).
• Install the 1157 style adapters into the correct factory pigtails. The adapters will be labeled (Passenger side brake pigtail, Passenger side Turn signal pigtail, Drivers side turn signal pigtail).
• Install the desired bulbs into the new pigtails that are provided with the sequential harness.
• Carefully re-install the tail lights and tuck the wiring in a save location, where it will not be damaged

Tinting Tail Lights:

• Most people use the spray-on tint for the exterior of the lenses ( VHT SP888 Red Nite Shades)
• https://www.amazon.ca/VHT-SP888-Red-Nite-Shades/dp/B005257R0O?th=1
• Other tinting methods can also be used.

Show Off Mode Enable:

• Turn off all lighting, so no power is being transmitted to the tail lights.
• Apply and hold the brake pedal
• While holding the brake pedal, toggle the running light switch (On – Off)
• Show off mode is now enabled, ***while you are depressing the brake pedal.***
• Alternatively, to keep the module in show off mode, while still holding the brake pedal, you can turn on the running light switch. You may now release the brake pedal, as the running light switch is providing power to the module.
• Once power to the module is removed, the module will reset and resume normal operating functions.